05-05-2019, 11:50 AM | #1 |
New Member
1
Rep 21
Posts |
2008 X5 C pillar exposed -help
does anyone have any photos of the c pillar without trim so i can see how the seat belt ratchet is installed??
or any info on it? how many plastic parts to remove so i can change rear passenger seat belt ratchet / retractor unit?? thanks |
05-05-2019, 12:17 PM | #2 |
New Member
1
Rep 21
Posts |
looks like you have to take the bigger lower one off first.. what is that one called.. goes almost over rear wheel in back of car... has a handle grip insert in it.. how do you get that mother of a trim piece out???
|
Appreciate
0
|
05-06-2019, 11:12 AM | #6 |
New Member
1
Rep 21
Posts |
ok.. i tried yanking on that handle and it did not pop off.. do i need to you use my plastic pry tools to get it off? what about after the handle?? is there a screw under the airbag labeled plastic tiny cover?? what else is there hiding??
|
Appreciate
0
|
05-06-2019, 11:38 AM | #7 |
Private
22
Rep 57
Posts |
You need to remove first the top C Pillar cover (torx screw under airbag cap)
Once you remove it you will see screws & clips on top of the bottom c pillar cover. Use a butterknife, flat crew driver or a thin pry tool to lift the rubber. lift it from the side located nearer to the back of the car. |
Appreciate
0
|
05-06-2019, 11:39 AM | #8 |
Private
22
Rep 57
Posts |
You need to remove first the top C Pillar cover (torx screw under airbag cap)
Once you remove it you will see screws & clips on top of the bottom c pillar cover. Use a butterknife, flat crew driver or a thin pry tool to lift the rubber. lift it from the side located nearer to the back of the car. |
Appreciate
0
|
05-06-2019, 01:42 PM | #9 |
New Member
1
Rep 21
Posts |
ok . but from what i saw there are 2 screws that go in holes on the bottom of the top cap.. as shown in photo i attached.. this being the case... do you not have to take off the bottom first?? or can the top cap come off first?? have you done this before...?
thanka |
Appreciate
0
|
05-07-2019, 12:41 PM | #12 |
New Member
1
Rep 21
Posts |
can anyone tell me how many screws are in the lower c panel cover?? i saw the one torx screw behind handle panel - are there any other screw or is it just pull and pry it off>>>>>??
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|