11-22-2021, 04:42 PM | #1 |
New Member
0
Rep 8
Posts |
WinKFP not displaying ZUSB buttons
Hello-
Just joined and trying to finish a problem I've had with an '09 X5. To keep it short, I replaced the VTG ATC700 module in the battery compartment due to water damage, I think. I need to program it and have WinKFP (SP-Daten files loaded and updated with Coding Tool) however when entering Comfort mode it doesn't show Enter, Choose or Update ZUSB, instead it says Identify ECU Family, Choose Custom or Update ECU, does this mean the same thing or did I miss something installing or in config? I'll be happy to share the full story going on for the past two months and lessons learned along the way. Thanks! |
11-23-2021, 01:16 PM | #2 |
New Member
0
Rep 8
Posts |
Found on another forum same functions just different names, guess English upgrade.
So if just coding a VIN to the VTG module (aka VGSG in INPA) do I need an external PSU, seems like it should only take a few minutes... |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|