|
|
|
| 02-18-2020, 02:48 PM | #1 |
|
Private
 
16
Rep 84
Posts |
Catalytic conversion code
Sooo. On Friday my coil on cylinder 3 went out. Replaced and all was good. Yesterday check engine light came on. I used my foxwell and it is showing a catalytic conversation code as well as a conversion 2 code.
I have been trying to read and comprehend what this issue is and for whatever reason I can't seem to follow what folks are saying. I just had the dealer replace the VANOS 2 months ago, car has been driving great. No issues at all. 2010 e70 3.0 with 105k miles
__________________
If it?s cheap it ain?t good, and if it?s good it ain?t cheap
|
| 02-18-2020, 03:43 PM | #2 |
|
Private
16
Rep 84
Posts |
specifically it says - 29F4 - DME Catalytic conversion, and then 29F5 DME catalytic conversion #2
It also says physical hardware #7569975
__________________
If it?s cheap it ain?t good, and if it?s good it ain?t cheap
|
|
Appreciate
0
|
| 02-18-2020, 06:34 PM | #3 |
|
Private
16
Rep 84
Posts |
watched another video and it was saying that I could possibly "melted" the ceramic in the catalytic converter when my cylinder 3 went out. unspent fuel goes in exhaust pipe then eventually fires and burns ceramic.
__________________
If it?s cheap it ain?t good, and if it?s good it ain?t cheap
|
|
Appreciate
0
|
| 02-18-2020, 06:46 PM | #4 |
|
Private
16
Rep 84
Posts |
I just ran a live test on O2 sensors, and one set reads 2.0 and the others read around .5 both match each other within a few degrees. I cleared the codes and after running car the check engine didnt come back on again?
__________________
If it?s cheap it ain?t good, and if it?s good it ain?t cheap
|
|
Appreciate
0
|
Post Reply |
| Bookmarks |
|
|
