05-27-2020, 11:26 AM | #1 |
New Member
1
Rep 15
Posts |
E70 question: replacing the fuel pump and under rear seat passenger side are the wires and connectors for the seat heaters, or something...One of the connectors got in a bind and snapped. So could I just connect the wires using tape or wire nut or some other method than trying to find the part?
The first picture is what it should look like and the second is what it looks like now, the third is what it looked like before the broken connector fell off |
05-27-2020, 12:47 PM | #2 |
Captain
107
Rep 994
Posts |
Quick fix, I'd solder and heat shrink it.
Long term I'd try to find a two pin connector setup, doesn't have to be OEM like. Even something from an RC car would suffice, and put that in place. |
Appreciate
0
|
05-27-2020, 12:49 PM | #3 | |
Major
274
Rep 1,054
Posts |
Quote:
https://lhishop.com/collections/cone...10-pairs-xt-60 Very high quality connector
__________________
2011 335d tuned by B.R.R.
2011 X5 35d tuned by B.R.R. |
|
Appreciate
2
argento538.00 what have i got into13.50 |
Post Reply |
Bookmarks |
|
|