[0-60Motorsports]

Originally Posted by X5MBeast

Thank you.

The catch cans are from amazon:

https://www.amazon.com/dp/B07RB4XBNH..._vtJlEbXMBJE83

https://www.amazon.com/dp/B07ZCSZR2R/ref=cm_sw_r_cp_api_i_JaKlEbXZDTM6N

I used M16x1.5 to AN10 adapters on the catch cans.
The hose was 3/4 inch ID 10 feet is enough to get the job done.
There’s a vent hose that connects to the oil separators on the valve cover. That flows into the catch can. The exit from the catch can goes to the filtered duct on the opposite bank.

The last picture from today. That was about 700 miles on the catch can. We’ve had a couple days of 30 degree weather here.

Thanks for the info. I might PM you some time to get some more info if you dont mind so i can source the parts for the Catch can setup etc.