Have any luck yet? I would have your mechanic use ISTA to do a simple height calibration. If you need to know the exact steps I can go through it, it's incredibly simple. I just did mine the other day when I had the left side sitting an inch low. This happened when I swapped the ride height sensors. Any time you mess with those they should be calibrated.
Only thing is that since you're lowered, when it asks for your measurements on both sides, you'll want to add your lowered amount to the measurement. Otherwise computer will think it's too low and try to raise it up. So if you're measurement is 675mm from bottom of rim to the fender arch, then you'll want to input 700mm(adding 25mm which is an inch) into the computer.
|