Update: I have finished the setup and install of the new CNC mill that I will be using to make a few parts for the intakes: Mounting brackets, screw bosses, & most importantly the fixture plates that will allow me to manufacture the intakes in single piece prints with superior strength & quality that will last the lifetime of the vehicle.
To dial in the mill and get it ready for production, I made up a simple test project: The M paper weight (or pet rock 2.0 lol). This was the very first cuts made on the mill and it turned out exceptionally well. I am going to make up a few more of these as I continue to get everything dialed in and the mill ready for the intake production. I will include one of these with every pre-order of the intakes just as a fun freebie
.
Expecting to begin intake production in a about a week, will update again as we get closer.