Thank you for the interest everyone, here is an Update: With the new addition of a CNC mill, I can now build fixtures that will allow me to print the air filter boxes much more efficiently with less material wasting supports and labor involved. This has delayed my roll-out but it is for the best and will vastly improve the quality of the intakes & strength making them virtually bulletproof.
I will also be using the mill to produce a complete CCV/Catch can solution for the M & 50i that will allow the use of clean -AN lines and fittings that will compliment the intake for the M & 50i and completely eliminating the need to use the stock plastic corrugated CCV lines that were always failure prone. If the CCV lines are an issue on the 35i & 35d I will also develop separate solutions for those platforms. Will update this thread as more progress is made, getting the new mill dialed in & setup now.
|