Quote:
Originally Posted by polar993
I just tried the load resistors with a set of H11 LEDs that I bought from CARid.com.
The load resistors were 50 watt ,6 ohm.
In installed them and the load resistors got incredibly hot within about 3 mins. They got so hot that even the positive and negative wires connecting them started to melt! Too dangerous to install!
For now, I just put the LED bulbs in and will deal with the warning light that says "bulb failure". I will be sure to check that they don't get overheated the next time I drive the car. If they do, I'll revert to stock, and go the halogen route.
Anyone else have any luck with LED fogs????
If so, please share!!!!
|
Anything like this will do:
http://www.flickr.com/photos/90792220@N04/8253163713/
Cree: powerful
Canbus: built in resistor, error free