So I repaired the ccv pipe with some aluminum dryer vent tape. Started up .. chug, chug for a second and then right into Cold Start and idling fine. Backed out of garage and dropped into drive and then it just started chugging again.. will run ok with throttle but idle basically stalls out.
Just got this thing last week.. 2 miles off the delivery truck I got an Eng Malfunction warning. I ended up finding open vac lines from exhaust valves. PO changed the exhaust. That was all good til yesterday when this happened. The saga shall continue
I suspect as I'm sealing up these vac leaks more are being exposed...