10-16-2011, 06:00 PM | #1 |
Private
23
Rep 53
Posts |
DSC and xDrive Malfunction
While driving down the highway the car jerked suddenly and the following malfunction lights came on:
"Chassis stabilization malfunction" "DSC and xDrive malfunction" - Chassis stabilization and traction reduced. Drive moderately. Have the system checked by the nearest BMW center. "DBC malfunction! Drive carefully" After the warning lights came on, the car of course drove in limp mode until I got home (thankfully 1mile away). After parking the truck and restarting the error lights went away and oddly drives normally as if nothing happened. Has anyone had this problem? I searched around a found several pre-2010 5-series owners having this issue with the cause being a faulty steering position sensor. I have a 2010 X5M w/11k miles and it hash't been serviced/been to a dealership since the purchase last Nov. Aside from this error, I did get the "power reduced error" once after hitting the rev limiter in 1st which went away after restarting. Also on a few occasions, normally on my way home in traffic, I've noticed the engine would sometimes emit a large amount of white smoke after some stop and go traffic, or when up-shifting under light/moderate load. I've asked ESS and they never heard of this issue. The truck has Akrapovic downpipes, SS catless downpipes, ESS reflash and K&N filters. I'm debating bring it in to the dealership, however I'm hesitant given the downpipes and reflash (very noticible). Any ideas? |
11-08-2011, 08:56 PM | #3 |
Private
23
Rep 53
Posts |
Its been about a month and a ~1000 miles worth of driving and I haven't had the issue reoccur. Since I'm due for my 1-year service and the upcoming water pump recall I'll have the dealership check the system, however I'll probably remove the downpipes and software first (leaving the exhaust on). Does anyone know if flashing back to the factory software will reset the trouble code memory?
|
Appreciate
0
|
11-08-2011, 09:16 PM | #4 | |
Lieutenant
44
Rep 567
Posts |
Quote:
How do you like the Downpipes, and did you install them after the Akra or at the same time?
__________________
| '10 Escalade ESV | '12 Audi S4 | '01 Audi S4 | '15 328d Xdrive M-Sportwagon |
|
|
Appreciate
0
|
11-09-2011, 09:50 AM | #5 | |
Private
23
Rep 53
Posts |
Quote:
I felt the biggest performance impact from the downpipes and downpipe reflash. ESS 91 octane software only: The truck felt much stronger off the line and in the mid-rpm range. The upper rpm range felt similar to stock. The shifts were also slightly better. Spending roughly 2k is worth it. ESS 91 octane Software + Akrapovic exhaust: The truck felt exactly the same, no noticeable improvement in performance. The cold start was slightly louder, and while driving, the truck had a slightly louder sound though it’s almost indistinguishable from inside. The shifts did have a slightly better pop, and the truck did feel slightly more nimble from the decent weight reduction. Personally I wouldn't pay 6k for this exhaust and expect a noticeable performance impact or significant change in sound (from inside the truck). If you look at the stock exhaust you’ll understand why its not much of a restriction. ESS 91octane downpipe software + Akrapovic exhaust + SS downpipes: The truck felt MUCH stronger and MUCH louder. The difference is stunning. The entire rpm range feels significantly stronger and the response after shifting seems much quicker, probably due to the decrease in backpressure. On cold start the truck is VERY loud. So loud that it will sound as if a race car started (and this is coming from someone who drag races 1200hp turbocharged cars). Spending 2k on downpipes is stupid, though the difference (with software) is great. A cost effective solution is only doing software and catless downpipes, though some said the exhaust sounds strange. Depending on what downpipes you get, I bet you can do software and downpipes for under 3k. Much better than the 10k setup I have, and will have similar performance to what I got, and while retaining the stock look. In normal mode and under normal throttle conditions the truck is louder than stock and emits a faint turbo whistle in the lower rpms. On occasion I do get some slight turbo surging (typically from heat soak after being in traffic) and mild on/off throttle hesitation, typical on factory turbo cars with similar mods. Only under full throttle (when the exhaust valves open) does the truck get very loud. Also the manual shifting in normal mode feels very sluggish and actually makes a louder and longer burble sound when shifting. In sport mode (exhaust valves always open) the truck feels very responsive and the shifting is crisp. Manual mode feels great and has a great quick pop sound. You'll also notice a stronger smell of gas/exhaust fumes in this mode as a result of the outer exhaust tips bypassing the muffler. In M-mode (all vehicle settings set to max performance): the truck feels great. Very responsive, quick shifts, great exhaust notes, VERY loud, and very twitchy in traffic. General Downsides: - You will get a strong smell of gas/exhaust fumes while driving in traffic, sitting at stop lights or during cold start or after a quick pull through the gears. I've actually had a few people pull next to me and complain while in traffic (though it’s the SF Bay Area, CA so I'm surprised). - From time to time I do get traces of detonation during partial throttle in lower rpms (exhaust is too loud to hear it in the upper rpm range). - On a few occasions I've noticed the truck emit plumes of white smoke (smells like oil) during normal acceleration/shifting after slowing down in the highway. No idea why this happens or why it rarely happens and it’s not repeatable. - I did have one engine malfunction error after hitting the rpm limiter in first gear under full throttle. After restarting the error went away and I've never had it happen in the past 5,000 miles). - I had the error described in this thread, however I've been unable to neither replicate it, nor do I know the cause. Unfortunately I'll need to remove the downpipes and reflash back to stock (leaving the exhaust) to avoid dealership issues. - The downpipe install is not fun. I did it myself (very experienced and have the correct tools) which took 2.5hrs. A normal user would have great difficulty doing this. Most shops would charge a ~5-8hrs for this job (350-1000 in labor depending on the rate) |
|
Appreciate
0
|
11-10-2011, 01:18 PM | #6 |
Lieutenant
44
Rep 567
Posts |
Maybe the error light came on because of the aftermarket software?
Water pump recall for what model years? I may have missed that recall. Thanks for the detailed response on the exhaust. Definitely doing the Akra AR design catless ESS tune. Could you describe the Downpipe removal? Heat shields etc? Special tools to work in tight spaces?
__________________
| '10 Escalade ESV | '12 Audi S4 | '01 Audi S4 | '15 328d Xdrive M-Sportwagon |
|
Appreciate
0
|
11-10-2011, 07:07 PM | #7 |
Lieutenant
44
Rep 567
Posts |
Forgot to ask above...
How many miles with the SS DP's and reflash?
__________________
| '10 Escalade ESV | '12 Audi S4 | '01 Audi S4 | '15 328d Xdrive M-Sportwagon |
|
Appreciate
0
|
03-14-2012, 02:23 PM | #9 |
Private
2
Rep 50
Posts |
I had a same problem plus servotronic malfunction error message on X6 about a month ago. I pulled out from my parking spot and realized that my car did not have much power with super-heavy steering wheel. I parked a car again and cursed a few times. I started to car a few minutes later and it has been okay since then. By the way, I am not suggesting that cursing fixed my car.
|
Appreciate
0
|
03-14-2012, 06:11 PM | #10 |
stankmouth
35
Rep 508
Posts |
i just had the reduced power engine malfunction message come up when i wound my truck up in first gear and it wasnt in M mode and i was 500miles from home, and it was a sunday got to my destination,ate breakfast and got back in my truck heart broken and it wasnt on anymore,then it came back on next morning turned it off again and it was gone...drove 500 miles home with no issues and took it to my guy to have it checked out anyway so he did a "smoke test" and i guess what it is,is that the stock vcuum for the turbos can be prone to minor leaking therefore affecting the pressure in one or both of the turbos and that can trigger the sensor. although supposedly the leakage is minimal and its not an issue with all trucks there is an upgraded system due to this fact. so i ordered it and itll be here next week. and btw the "check engine light" has not been back on since, but they still recommended having it upgraded.
|
Appreciate
0
|
03-15-2012, 07:19 PM | #11 |
Second Lieutenant
25
Rep 289
Posts |
This just happened to my x6 after going for a walk this morning,got all the warning lights,no power steering{now it does feel like a truck).
I hope this goes away by itself,after water and oil pump replacement,i do not feel like going to the dealer again |
Appreciate
1
ISMERX51.00 |
03-16-2012, 08:14 AM | #12 |
Second Lieutenant
25
Rep 289
Posts |
Went for a drive later in the day,no warnings,back to normal
|
Appreciate
0
|
03-19-2012, 02:45 PM | #13 |
Registered
0
Rep 3
Posts |
I had the same problem with my 2012 X6. Three weeks after getting the care the error popped up. Dealer called it a glitch. The fault code would clear out once you let the car "sleep". To make a long story short (3 more visits later) the tech had to consult with BMW engineers and was told to replace the TRANSFER CASE.
I got my car back last friday, no issues overt there weekend. |
Appreciate
0
|
05-08-2013, 11:15 PM | #14 |
New Member
0
Rep 7
Posts |
2013 x5 35 i M sport , 5K milage ,got following error
-parking brake malfunction and also followings in the same time -Braking/chassis stabilization malfunction -FTM system error -parking brake malfunction both above happened few times and restarting the engine clear it. Dealer scan the car and said left speed sensor caused the issue .the said corroded pins on left wheel speed sensor .They ordered new one and swapped it with right one to see is it the root cause or some thing else .I will go to dealer to put the new one next week ,in mean time I got couple of more malfunction messages so they will find if the sensor is faulty or some thing else. I do not understand why 6 months old car has corroded pins ,may be water leak inside it during car wash ? I checked the wiring harness behind front wheels that go to the black box that connect to the sensors ,the wiring harness are there without any shield (surprise to see it from german engineer car).they could simply tape the wiring harness with waterproof tape and make the plastic box waterproof . Any way , I will let you know what will happen next week when I go to dealer to scan the car and replace faulty speed sensor . |
Appreciate
0
|
05-13-2013, 08:54 PM | #15 | |
New Member
0
Rep 7
Posts |
Quote:
|
|
Appreciate
0
|
07-16-2013, 07:17 AM | #16 |
Captain
102
Rep 936
Posts |
Sorry to grave dig urgent question.
My dads 2008 x5 4.8i 85000km just got this issue exctly the same as OP. wont accelerate 4x4 AWD DSC has malfunction. My local car repair shop which specalizes in german cars has found out it needs a new transfer case. They quoted me $1200 for the part but when i check online the transfer case cost $2000 Can anyone give me there part number of the teansfer case that there dealer replaced? I dont want my local dealer to get the part for cheap then double the price and sell to me. |
Appreciate
0
|
07-16-2013, 07:49 AM | #17 |
Private
7
Rep 56
Posts |
I just got my car back from BMW after a month of being in the shop. I had the 4x4 and dsc malfunction followed by engine malfunction the second time.
I had this come up right as I was making a quick left to avoid on coming traffic. The reduced power nearly killed my son and I. Like you, I turned off the car and cursed and turned it back on and all was fine again. Drove around for 2 hours and then while in the fast lane on the highway, engine malfunction came up with the reduced power into limp mode again. Car slowed down immediately while going over 110km/h almost killing my son and I a second time. It reduced speed from 110 to 75 in no time. they said it was the throttle body harness wiring .. after this incident, I have decided to sell my vehicle. I have had nothing but issues with it since day one of ownership. unfortunate but probably first and last BMW. Last edited by Jlam86; 07-16-2013 at 08:29 AM.. |
Appreciate
0
|
05-23-2015, 05:45 PM | #18 |
Registered
0
Rep 1
Posts |
I also had the same DSC and Xdrive malfunction followed with the brake malfunction. I turned the wheel to the left and right, waited an hour then started her up and she was fine. Is there anything I should keep my eye out for?
|
Appreciate
0
|
05-26-2015, 10:55 AM | #19 |
Captain
43
Rep 708
Posts |
I had the same error message pop up on my car last night, driving home after the holiday weekend. Didn't reduce power or anything, but disabled cruise control which sucked because I had 75 miles to go to get home.
will be having the dealer check it out. |
Appreciate
0
|
05-26-2015, 11:39 AM | #20 |
Banned
528
Rep 2,822
Posts
Drives: X5M F85
Join Date: Aug 2008
Location: SI NY
|
I think this might have something to do with our batteries. I know i get this error when i disconnect and reconnect the battery. I usually drive around the block and then turn off and restart the car and the error no longer appears. Just an idea.
|
Appreciate
0
|
05-26-2015, 10:04 PM | #21 |
Private First Class
29
Rep 118
Posts |
had the same error a month or two ago. it would only happen at highway speeds, never around town. it turns out the dealer needed to recalibrate the steering sensor. the error has not returned since....good luck
|
Appreciate
0
|
08-14-2018, 05:17 PM | #22 | |
New Member
1
Rep 16
Posts |
Quote:
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|