06-19-2020, 01:30 PM | #1 |
New Member
0
Rep 7
Posts |
2008 X5 V8 4.8i E70 Suspension
So just bought this x5 it had a couple camshaft position codes that was all, replaced 2 camshaft sensors still have that problem and dont know what i should do to clear the camshaft engine codes, Bank B intake and exhaust or something like that... BUT... My main problem is that now the back end is squatting all the way and the suspension level control system malfunction. Idk if maybe there are common fixes for this or if maybe the air pump goes out alot or typical after 12 years... I looked at each wheel area for the little connector rods hoping maybe one popped off but i couldnt see anything wrong amd my bimmer has like no suspension now.
|
06-19-2020, 02:24 PM | #3 | |
Captain
538
Rep 872
Posts |
Quote:
https://www.realoem.com/bmw/enUS/sho...diagId=33_1389
__________________
2013 X5M AW/Blk
Build Thread: https://www.xbimmers.com/forums/show....php?t=1499820 |
|
Appreciate
0
|
06-20-2020, 12:05 AM | #5 | |
Captain
538
Rep 872
Posts |
Quote:
Then here: I haven't done, but doesn't look too bad. Good luck.
__________________
2013 X5M AW/Blk
Build Thread: https://www.xbimmers.com/forums/show....php?t=1499820 |
|
Appreciate
0
|
06-21-2020, 12:00 AM | #6 |
New Member
0
Rep 7
Posts |
Awesome! Problem solved for my suspension, shall i make a new post on my camshaft position sensor problems im running a few codes all camshaft position one is over advanced somethong and one is exhaust and intake and one more i believe but the new camshaft position sensors on both sides didnt fix it. I did the ones in the back of the engine on top one on both sides
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|