12-02-2021, 07:30 AM | #1 |
Private First Class
23
Rep 155
Posts |
E70 Lift Gate Module
Featured on BIMMERPOST.com Can a module with a non matching part # be coded to work properly? Thx! |
01-01-2022, 09:44 PM | #2 |
New Member
0
Rep 5
Posts |
I've been battling tailgate lift issues as well.
I found this video, hope it helps! https://youtu.be/JBhoU37Wi24?t=187 |
Appreciate
0
|
01-06-2022, 12:25 PM | #3 |
New Member
5
Rep 16
Posts |
Hey I had a similar issue. I used a different part number lift gate module from a local guy who was parting out a pre-lci on my lci X5 and it worked fine without needing to code. Plugs were the same although the board and plug placement were slightly different and it even re-coded to open/close via the button afterward.
Also, my module got wet due to a leaf getting caught in my rear sunroof drain. Make sure that you clean those out with a wire and/or compressed air. Also take a small drill bit and drill a hole in the plastic plug in the wheel well for added protection against it filling up with water again. Electronics submerged in a tub with no drain is a recipe for disaster. Last edited by SupDuc; 01-06-2022 at 12:32 PM.. |
Appreciate
1
Al302923.00 |
01-08-2022, 01:04 PM | #4 | |
Private First Class
23
Rep 155
Posts |
Quote:
Still searching for identical part #, since then i drilled a few holes so that the water will drain and wrapped the bracket with flex seal. |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|