07-23-2016, 02:19 PM | #1 |
New Member
5
Rep 8
Posts |
2012 X6M LF pdc sensor access?
Gents,
Reaching out to see if you can advise me of access to the LF PDC Sensor and mounting? I ran over some stuff in the garage while storing the X6M last night, It flexed the front bumper cover and popped-out the LF pdc sensor from mounting bracket. Can you help by telling me best way to access and re-install or replace PDC bracket, if damaged? 1) Does the bumper cover have to come off or? 2) Remove LF wheel and remove inner wheel vent+ rivets to access?? Please advise? Thanks in advance! |
07-24-2016, 09:21 PM | #2 |
New Member
5
Rep 8
Posts |
Fixed
Gents,
today no rain so I raised the car and accessed the LF PDC Sensor from underneath. There are several 8mm screws that I loosened and was able to look inside to see the adhesive became separated from one side of the pdc bracket. I cleaned the area with mineral spirits and applied some double sided 3m tape to re-secure the pdc bracket/sensor assembly to the bumper cover. All good now. I was lucky, no cosmetic damage. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|