06-04-2019, 04:00 PM | #1 |
New Member
2
Rep 23
Posts |
Turbo Coolant Lines - Not covered by warranty
Hi all,
My Valve Stems Seals were approved under the Service Bulleting for my 2013 X5 50i. My SA suggested replacing the Turbo Coolant Lines as well but quoted me just under 2k to do the job. Is there a DIY for this? I where would you reccomend getting replacement parts? I have never tackled anything outside of your basic oil change. Do I hit up my local indy and bite the bullet or try and tackle myself? Thanks in advance! |
06-12-2019, 03:44 PM | #2 |
Captain
217
Rep 780
Posts |
Ask Indy about the Valve stem seals and also ask him about getting the lines done at the same, would that save you any time or money or not?
My guess is, while the thing is apart, get what ever is easily accessible while you are in there stuff? $2000 from what I understand, sounds bit on the higher side Last edited by quick; 06-12-2019 at 03:51 PM.. |
Appreciate
0
|
06-12-2019, 04:08 PM | #3 | |
Brigadier General
2152
Rep 3,654
Posts |
Quote:
BMW Seattle did my coolant lines in 2016 - I have my paperwork right here and I paid about $1850. There's about a dozen parts listed - parts were 1/3, labor 2/3's of the total bill. Not sure about a DIY, maybe if you search something would come up BTW, mine failed while my X5 was still covered by CPO, and they were not covered either. CPO actually has a lot of exclusions. I have a 3rd party warranty now that covers everything - too bad mine failed so early and not when I had my currently warranty. |
|
Appreciate
0
|
06-13-2019, 07:26 AM | #4 |
Lieutenant Colonel
1416
Rep 1,564
Posts |
You can actually do it yourself for less then a hundred dollars and in a few hours or less... The reason why it's so expensive from the dealer is they replace the entire coolant lines, including the metal tubing that bolts to the turbos. This requires removing the turbos which takes a good 10+ hours to do. The metal part of the coolant lines dont need to be replaced, just the rubber which are very easy to access. Below is a link to a diy for the 550i which had the idential engine as the 50i...oh and when you get done, throw away your engine cover. It's one of the reasons the coolant tubes go bad so fast, trapping heat and wearing everything out that much quicker.
If you do decide to take off the turbos and replace the entire lines, I highly recommend you replace the cylinder head to cylinder head coolant tube and also your turbo oil return lines and oil return housing. Will cost you a few hundred in parts but easy to do while the turbos are off and these typically go bad around 70-100k because BMW can be a real dick sometimes with their use of plastic and cheap rubber (the oil return lines are all metal but can clog from oil boiling and coking them up as they sit right next to the exhaust manifolds) https://f10.5post.com/forums/showthread.php?t=1124308 Last edited by Sophisticated Redneck; 06-13-2019 at 07:39 AM.. |
Appreciate
0
|
06-13-2019, 01:54 PM | #5 | |
Second Lieutenant
20
Rep 264
Posts |
Quote:
|
|
Appreciate
0
|
06-13-2019, 05:13 PM | #6 | |
New Member
2
Rep 23
Posts |
Quote:
Thank you! |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|