10-08-2015, 03:53 PM | #67 |
Private First Class
19
Rep 127
Posts |
I thought so too. I printed out badassfajita's results and took it to the dealer. The SA stated that they would ask the tech to match the numbers. Upon speaking to the SA via phone yesterday (before pickup) the SA stated that the tech couldn't match the TOE numbers to match badassfajita's results because his X5 had 'Active Steering'. I stated to the SA that I'd take a look at the report when I came in.
I arrived and got the report but the SA wasn't there. I saw the toe was high but I paid and left. Should I reach out to the SA to do it again? |
Appreciate
0
|
10-08-2015, 04:45 PM | #68 | |
Major
363
Rep 1,343
Posts |
Quote:
|
|
Appreciate
0
|
10-08-2015, 08:49 PM | #69 | |
Captain
71
Rep 600
Posts |
Quote:
To get numbers like 0.02 on each wheel takes about 10 minutes per wheel because of drift and suspension movement when you're pulling on the eccentrics with a wrench. So it take patience to do it right! Get it redone. Don't accept "no" for an answer. Stay with the car and ask for a read-out BEFORE they get it off the rack. Next time (and there will be a next time) ... don't go to the dealer.
__________________
PAX5
BMWCCA 20645 |
|
Appreciate
0
|
10-08-2015, 11:00 PM | #70 | ||
Private First Class
19
Rep 127
Posts |
Quote:
I'll call them tomorrow. |
||
Appreciate
0
|
10-08-2015, 11:01 PM | #71 | ||
Private First Class
19
Rep 127
Posts |
Quote:
|
||
Appreciate
0
|
10-16-2015, 02:46 PM | #72 |
Private First Class
37
Rep 136
Posts
Drives: X5 35d X
Join Date: Dec 2013
Location: Earth
|
I changed to the DWS tires about six weeks ago and I must say the ride is great and they are much quieter than the run flats. I have also towed my travel trailer with the new DWS tires and the handling is still great.
I have an appt with the dealer on the 19th for an alignment and they say it's $189 or $289 cdn if you have Active Steering. How can you tell if you have A/S or not as the dealer said most cars don't have it. |
Appreciate
0
|
02-20-2017, 06:06 PM | #73 |
Captain
161
Rep 714
Posts |
Hunter Alignment
Been dealing with the tire wear issue here too - outside fronts, inside rears. Fronts are worse. I have 12k miles on the OE set of DUELER H/P SPORT Runflats.
In an attempt get a few more miles out of this set I decided get an alignment now, ahead of my next set of tires. I've read all the info on this forum and the "perfect" numbers a few here keep offering up - thanks. I took mine in today and here are the before /after numbers. Another data point for you all: Front Toe was reduced overall by almost half. Rear Toe actually is increased but with reduction in camber should reduce the wear I am seeing. At least my Thrust Angle is spot on! I know they are not exactly what is suggested in other posts as 'optimal'. The tech took into account how my tires were wearing and how I wanted to reduce that. He didn't go as far out of spec as I asked. I don't really know why they don't just do what you ask them. He did spend some time on it, especially the fronts, as the tie rod ends were stuck. Also he did keep the steering wheel centered. He mentioned the telescoping wheel complicated it a bit as he wanted to make sure it stayed centered while extended, not just retracted while car was shut off. It doesn't really feel any different with these small adjustments - I didn't expect any. As far as wear, these tires are so far gone in front all I am trying to do is buy enough time to tire shop and decide if I should run the fronts long enough to do the rears at the same time. *** EDIT *** After studying this above alignment printout some more, I am thoroughly confused by it. The confusion started when talking to the tech after the service. He and I were using opposite terminology when talking about positive or negative toe. Now I see on the printout it doesn't specify TOE-IN, but I assume it means that (not Toe-Out). So any positive value means toe-IN, and a negative value would be toe-OUT? Now you have the tiny illustrations of each setting, like Toe, showing the tires pointing OUT - which implies "NEGATIVE Toe-OUT". Does that pic change with your tires setting? Then what the hell are those little arrows above each given range? They vary from right to left but I can't see if they mean the current setting within that range, or something else. They are not consistent. Here is the single most helpful breakdown of all alignment settings and what effect they have on handling and tire wear. Brilliantly written: https://www.tirerack.com/tires/tiret...e.jsp?techid=4 However it doesn't help me read that infernal alignment printout any better. To boot, the tire with the worst wear (right front, outside edge) appears to have had much less "positive Toe-In" than the left side (assuming I am reading this printout right), so how did it wear so badly?
__________________
heatmizr [Todd]
g26 i4 e40 - Clean Machine e70 X5 50i M-Sport "The Boss" Loaded e90 328i - sold e36 M3 - Gone to become a track star Last edited by heatmizr; 03-03-2017 at 09:26 AM.. |
Appreciate
0
|
02-21-2017, 04:57 PM | #74 |
MGySgt
848
Rep 1,346
Posts
Drives: See Garage List! ;-)
Join Date: Mar 2014
Location: NORVA
iTrader: (0)
Garage List 2010 M5 [9.67]
2016 BMW 340xi M Sport [9.50] 2019 X5 50i M Sport [8.17] 2010 535xi [10.00] 2013 M5 [10.00] 2012 X5 M [10.00] |
I never let other than BMW perform an alignment! Because of the "weighing down" of the vehicle, etc.
__________________
JMD
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|