|
This might sound dumb, but I have tried this and it helped me identify where to plug in connectors.
Make sure line isn’t being held or routed incorrectly away from where it naturally lays first. You want any and all available slack from where it leaves or exits the main harnes it connects back to.
Then while pulling the wire move it in a circular motion drawing a large as possible circle using the wire as a radius so to speak. Pay attention to all components the wire could potentially reach. Then inspect that entire area and all components to ensure you didn’t miss a connector point.
Again, this sounds dumb, but forces you to look at any 0lace the connector could reach.
|