Ok, ive got 2010 E70 (FF03 -US market) X5 35D (M57d30t2) WITH sport package and I got DCT ("-"left and "+" right) steering wheel installed, all buttons and heating of steering are working properly, ive got slip ring connector wires #2 and #4 directly wired to transmission X8532 (that goes into the transmission mechatronic aka A7000a) #5 and #4 respectively.
Does anyone have a clear answer of what should I add to VO???
What coding do i need in order for this to work?
All i know that i will probably need to change value (wert_01) for paddle shift to some other value!
Quote:
Originally Posted by ZetaTre
Ok, I finally got confirmation of my suspicion in a discussion over on another board where I met some familiar faces.
The upshift signal goes from pin #2 in X1880 to pin #5 in X8532; the downshift signal goes from pin #4 of X1880 to pin #4 in X8532.
If the paddle shift are switch based the "simple" wiring should be enough to have them working; if they are resistance based (and I think the +/- style are) you either try to add $2XA to the VO and change the EGS parameter "PADDLE" to wert_02; or you hack the paddle open, remove the resistor and convert it into a simple switch...
|
One of my buddies have 03/13 X5 with actual M-Sport package he has option $7XA
BUT i read his "Kombi.E70.C03", his "GWS.E70.C08" and his *EGS("GKE11KC08") (all modules and parameters with NCSExpert) and there is NO options for paddles!
Im wondering if option $2XA will give me the ability to change wert_02 to...