|
Dextrous
I have the exact same issue and found both the low pressure fuel temp sensor part# 13-53-7-806-960 as well as the high pressure Fuel Quantity Control Valve part# 1465ZS0097 both full of diesel. I've replaced the control value already and waiting on the other part. DDE I was able to remove the board and clean it then used a heat gun and it appears to be working again. My question is could there be any other item that caused this that could have just pushed the fuel to those two parts? I've check the connectors at each injector and they are dry. Also did your replacing the low pressure fuel supply line correct the problem. I'm concerned because the loom connected to that sensor shows about 1/2 inch of the wire before going into the loom. Not sure I understand how the fuel got to the DDE.
|