Quote:
Originally Posted by Maxx2
1) That is correct. The actual measurements were:
Front
--------
.715in (18.161mm)
Rear
-------
.775in (19.685mm)
2) Not sure where you are going with this one... this is what you wrote;
The fact that you have been using spacers for many years has no relevance. Please provide actual data if you would like to prove a point.
|
Seriously, find me a 25mm spacer or a 4 inch spacer that uses a bolt straight through... Think for a second... If they aren't produced it is clearly because the studs or bolts cannot support the load... The 2 piece spacer system is just as safe as the limited available widths of 20mm and below on a single bolt bearing spacer. As long as you bought them from a reputable manufacturer