|
I work second shift at Boeing, working from 12:30pm-1am, so I haven't gotten fully into the install yet. Yesterday I flashed both modules, today I pulled the kick panel, a few harnesses and then ran outta time while trying to be OCD about the routing.
I watched their install video on a 3 series, but I'm going to go a step further by removing one heater duct so I can neatly route the wiring and get easier access to the brake switch. I figure if I had a good 3hrs straight time, this could be done. Since the 3 series is slightly different, I'm going to document my install with some pics and create a new how-to thread (I'll link it here) that's more E7* specific.
|