Quote:
Originally Posted by igorbmwx6
I am planning to do this retrofit myself, as time and local weather permits. Hopefully one day would be enough time to get it done from start to end, including coding FRM-3 module at the end. Did you do this retrofit? What should I watch out for? When I run the new LED wire harness, at what places for it enter and exit the cabin and engine compartment on both left and right hand sides?
|
I didn't do it myself, but it isn't hard. You just have to stick to the instructions, which are a bit dull in informatory terms. You will run the wires only through one side - the drivers, but that is also covered in instructions.