[argento]

EDIT: See post #58, I assumed an impedance of 4 ohms in this post...below I actually measured impedance and it's 6.5 ohms....


B&W Tweeter 65-13-9-279-629, Capacitance (measured w/multimeter) = 4.67 uF, which calculates to about XXXX Hz, High Pass.

The mfg left the shrink wrap open on the ends presumably to quality control the capacitance after assembly. I was on my way to cutting off the shrink wrap when I noticed.

I haven't popped in the tweeter, but it appears to be a direct fit, at least on the center dash mount. I will disassemble the D-Pillar speaker mounts next...the ones I bought from eBay so as not to damage the ones I'll be removing from the M.