Quote:
Originally Posted by 1jwhite
Yes it is about 1700 psi. I have an autel maxi sys but not seeing anything about resetting adaptations. Might need itsa for that? It was running before rebuild... so frustrating. Could i possibly have the crank 360 degrees out when i set the cams?
|
It's been a few years since I did mine so I'm a little fuzzy on th details but when you drop the alignment pin in on the crank, cylinder one is supposed to be at TDC or close to it, I would check your at TDC on cylinder 1 when your setting cam timing. I'm pretty sure it's TDC on tb compression stroke so if your 360 out then the exhaust valves will just have closed so watch them when rotating. Double check everything I said though if TDC is on compression stroke for the n63, as I mentioned Its been a few years.