Quote:
Originally Posted by Colodano
Honestly it was not that bad at all. Looking at some other pictures, the stock partitions use screws where I thought I needed to use the plastic clips, so that was my whole issue there.
The small holes for the pads are 10 seconds with a drill, and 30 seconds to remove from the old ones.
I was wandering around and doing other stuff as well, and it took me around 20 minutes to change them out.
As I look at them, I do wish that I did one thing different. I started taping at the top and worked down, but if I had gone from the bottom up, the top tape would be the widest, and it is the one you see the best. Also there is a chance for moisture to collect on the lip of the tape, and it would be on the bottom side the other way. Oh well.
|
another good tip
I'll make sure to start from the bottom
I have the partitions just waiting for the tape to arrive, it's been over a month since I ordered it in China thru Ali.